2 Operation
2 - 47
Delete a Program
In the “PRNO” mode, move the cursor to the program to be deleted and press the
key. The following message displays:
Fig. 2-44
At this time, press the key to delete the program O02. When you press the
key, no action is performed.
To delete all programs 0~999, follow the procedures below: Procedure:
Switch to the MDI mode and instruct the command G10 P2001. All contents in the
program are deleted.
Note: After the procedure is complete, all program data in memory is erased.
Therefore, never perform this action unless it is absolutely necessary.
Delete
Y
N
To Next Page
Loading...