HUST CNC H6D-T Manual
2 - 48
2.2.2.3. Entering Fractions
(1) The entered command values shall be divided into integral and decimal point
numbers, and up to 7 digits shall be entered at most. Because the decimal point
cannot be accepted by the command value to be indicated with integral number,
there would be no problem for inputting the value for this type of command. As
for the decimal point-type command value, the decimal point shall be entered at
the appropriate position (the “0” following the decimal point can be omitted); after
internal processing by the Controller, its value will be the correct one. Under
varied modes, actual command value entered by integral number will also be
different. Provided below is about the description of “If to start the decimal point
omission” (such parameter is shown in the first page of Parameter screen and it
can be accessed by clicking “IO / MCM” for twice.
Enter
Non-starting
Omission
Starting Omission
X2 X0.002 mm X2mm
Z35 Z0.035 mm X35mm
U2500 U2.500 mm U2500mm
W125. W125.000 mm W125mm
(2) The command value to be entered by integral number:
G, M, N, S code: Computation parameters.
Suggestion: To avoid confusion, except that integral number should be entered for G, M,
N and S, other commands will be entered by decimal point method and the “0”
following the effective number can be omitted.
2.2.2.4. Editing Notes
Block (Program) Serial number
1. The letter N of the block serial number can be omitted if necessary.
2. The number after N is only a symbol. The blocks are sorted in line order rather
than the assigned line value.
For instance, if N35 is inserted behind N30, the order is:
To Next Page
Loading...