HUST CNC H6D-T - Page 64

HUST CNC H6D-T Manual
3 - 2
The G-codes of H6D-T controller are listed in Table 3-1.
Table 3-1 G-Code Definitions
G-code Function
*00 Positioning (fast feed-rate)
*01 #
Linear cutting (cutting feed-rate)
*02 Circular interpolation, CW (cutter at rear)
*03
Circular interpolation, CCW (cutter at rear)
04 Dwell (Feed-hold)
05
Parabolic cutting
09
Exact stop check
15
Spindle positioning command
16
Cylindrical plane
17-19
Plane selection
20 System measurement in INCH mode
21 System measurement in METRIC mode
28 Automatic reference position return
29 Return from reference position
30 2nd reference position return
31 Skip function
32
Thread cutting
33
Tapping Cutting Canned Cycle
34
Variable lead thread cutting
*40 # Tool radius compensation - cancel
*41 Tool radius compensation - set (left)
*42 Tool radius compensation - set (right)
Local Coordinate System Setting
Basic machine coordinate system
54-59
Coordinate System Setting
* 61
Exact stop check mode
* 62
Exact stop check mode cancel
70 Finishing cycle
71 Longitudinal rough cutting cycle
72 Face rough cutting cycle
73 Formed material rough cutting cycle