3 G/M Codes
3 - 3
G-code Function
74 Face cut-off cycle
75 Longitudinal cut-off cycle
76
Compound thread cutting cycle
80 # Fixed cycle for drilling cancel
* 83 Deep hole drilling cycle (Z axis)
* 84 Tapping cycle
90 Longitudinal cutting fixed cycle
* 92
Thread cutting fixed cycle
* 94 Face cutting fixed cycle
*96 Constant surface speed control ON
*97 # Constant surface speed control OFF
*98
Feed per minute mm/min or in/min
*99 #
Feed per revolution mm/revolution or in/revolution
# -- G-codes with "#" are of power-on default setting.
* -- G-codes with "*" are modal G-codes.
-- Function code prefixed with mark needs to be carried out in
G99 mode.
To Next Page
Loading...