3 G/M Codes
3 - 5
G0 X4.00 W-3.05 X and Z-axes are set with absolute or incremental
commands
Fig. 3-2 G00 Programming Example
Tool moves to X4.00, Z5.60 rapidly. Since both X and Z axes are repositioning, the tool
moves according to the lower feed-rate set in the parameter “Highest Feed-rate”.Ex:
Fig. 3-2 assuming that the “Highest Feed-rate” is:
X = 5000.00 mm/min, Z = 3000.00 mm/min,
Then Fz =3000.00 Z-axis feed-rate
Fx = 3000.00 * (3.00/3.05)
= 2950.82 (less than 5000.0, X- axis set value) X-axis feed-rate
The feed rate of both axes is within the MCM parameter settings. Therefore, the tool
will feed at the calculated rate on both axes.
When only a single axis (X or Z) executes fast positioning, it moves at the respective
speed set in the “Highest Feed-rate” parameter.
3.3 Linear Cutting, G01
Functions and Purposes:
This command, together with the coordinates and a feed speed command, makes the
tool to move from the current position to the end point specified by the coordinates in a
linear movement at the speed specified by address F.
Format:
B
x
z
5.6
3.05
3.00
2.00
To Next Page
Loading...