HUST CNC H6D-T - Page 74

HUST CNC H6D-T Manual
3 - 12
The minimum dwell time is 0.001 sec, the maximum is 8000.0 seconds.
Ex: N1 G1 X10.000 Z10.000 F0.1
N2 G4 X2.000 hold for 2 seconds
N3 G00 X0.000 Z0.000
3.6 Parabolic cutting, G05
Function and purpose
The function will make the tool along a parabolic mobile.
Form :
G05 X(U)___ Z(W)___ P___ I___ K___ J___ F___
X,Z : The parabola the end of the absolute coordinates value.
U,W : The parabola the end of the incremental value relative to the starting point
of the single block.
Note When parabolic End X coordinate and the parabola starting point X coordinate
equal, display will showing “ERROR 05 .X”.
When parabolic End Z coordinate and the parabola starting point Z coordinate
equal, display will showing “ERROR 05 .Z”.
P : Parabolic program X
2
=4PZ P value, Range 1 9999999 , Unit 0.001mm,
Degree of opening of said parabolic shape. When P 0, system will showing
“ERROR 05.P” to the display
I : The parabola X-axis interpolation step value, Range 0.001 9999.999 Step away
from the smaller, the precision will more higher. When the X-axis step distance
value I 0 , system will showing “ERROR 05 .I” to the display
K : K=0 Counterclockwise parabolic parabola trajectory from the beginning to the end.