3 G/M Codes
3 - 13
K=1 Parabolic trajectory from the beginning to the end clockwise parabolic.
The system default counterclockwise parabolic when K not fill.
J : J=0 The parabola command in prevenient processing can do tool compensation,
but the surface finish is not high.
J=1 The parabola command in at the point of interruption, can not do the tool
compensation but high surface finish.
The system default J=0 when J not fill.
F : Speed feed-rate (Can be used in conjunction with any G-code).
Fig 3-11 K explanation
Rear turret coordinates
Front turret coordinates
To Next Page
Loading...