6
Connecting the heater to the power supply
• A method to disconnect all poles from the mains (a circuit
breaker) must be installed on the power circuit before the sauna
controller.
• Only a certified electrician is allowed to connect the heater to
the power supply.
• The power cable of the heater must meet the requirements of UL
62 in US and CSA 49 in Canada.
• It is recommended to connect the unit to the mains without an
earth-leakage circuit breaker.
• The maximum current intensity in the cross-sectional area of the
cable and circuit breaker are listed in Table 2.
• The cable must be secured to the clamp on the cover screw.
Aention! It is forbidden to use a non-heat-resistant cable with PVC
isolation as the power cable. The joint box must be waterproof and it
must be located up to 19.7 in 50 cm) from the floor.
• Open the cover of the heater’s electrical box.
• Aach the power cable on the terminal block according to the
circuit diagram.
• Close the cover.
• Fix the cable on the output with a cable strap.
To Next Page
