HUUM HIVE - Fitting the Stones; Controlling the Heater

7
Fiing the stones
• Make sure that the heating elements are not bent during the
process.
• There must be suicient air circulation around the heater
elements.
• Stack the stones sparsely between the heating elements. If the
stones have been stacked too close to each other, the heating
elements may overheat (= shorter useful life) and slow the
heating of the sauna.
• Stones with a diameter of 3.156.3 in 8–16 cm) are suitable for
the heater.
• The stones on the external surface of the heater must be
stacked close to one another. The heating elements must not be
visible.
• Using ceramic stones in the HIVE heater is allowed at the user’s
responsibility.
ATTENTION! IF THE STONE CONTAINER IS FILLED TOO SPARSELY, IT
POSES A FIRE HAZARD!
Before switching the heater on, the insulation resistance might prove
to be lower than the standard. The reason for that is the moisture that
seeped into the insulating layer during storage in the warehouse and
transportation.
The moisture evaporates after the electric heater has been heated
for 1–2 hours.
CONTROLLING THE HEATER
All certified control panels with thermal control may be used in
controlling the heater. The output of the heater must remain in the