8
interval determined by the control panel’s producer.
Product can be used only with controlunit with timer function. Inclu-
ding other than those for installation in public saunas, shall be provi-
ded with a timer. For appliances for use in blocks of flats, hotels and
similar locations, the operating period of the sauna heater shall be
limited to 12 h with a minimum rest period of 6 h before any automatic
restarting. For other appliances, the operating period of the timer
shall be limited to 6 h, automatic restarting not being allowed.
GUARD RAILS
• It is recommended to construct a guard rail around the heater.
We recommend using materials with low heat capacity and bad
thermal conductivity for the guard rail.
• Upon using flammable materials, it is necessary to leave the
specified minimal safety clearances between the heater and
flammable constructions.
ATTENTION! IF THE HEATER IS INSTALLED CLOSER TO FLAMMABLE
CONSTRUCTIONS THAN AT THE DISTANCE OF THE MINIMAL REQUIRED
PROTECTION BELT IT MAY CAUSE A FIRE HAZARD!
SAUNA ROOM
Wall materials and insulating the sauna room
In a sauna with electric heating, all massive heat accumulating wall
surfaces (brick, glass brick, rendering etc.) must be insulated to use
the electric heater with a regular output.
The sauna wall and ceiling construction is considered to be suf-
ficiently insulated:
• a carefully installed insulation wool layer of 4 in, minimum 2 in
100 mm, min. 50 mm);
• the construction is damp proofed with taped aluminium paper or
To Next Page
Loading...
