Page 16 of 20 pages
Start with the uppermost slab, two slabs in all for HWAM 7150 and three slabs for HWAM 7180. Please
be careful; the stone slabs are quite heavy.
If the stove has rear outlet, lift off the convection grate (1) and both top plates (2 + 3). Lift off the
slabs (4) on the front left-hand side of the stove by first lifting the slabs and then removing them. Start
with the uppermost slab, two slabs in all for HWAM 7150 and three slabs for HWAM 7180. Please be
careful; the stone slabs are quite heavy.
On a cold stove, the starting point of the feeler is controlled. The starting point on a cold stove is about
30
0
above horizontal. It should feel easy going and bouncy when you push it, no matter if the stove is
cold or hot. By rising or falling temperatures it must not move at a bound. The damper plates must be
dry and clean and slide together unhindered. Control bars and slide gates may have to be smeared with
WD40 (never oil).
Door/glass
A sooty glass door can easily be cleaned with a piece of moist kitchen roll dipped in ash. Go about it in
vertical movements (up and down). Follow up with a dry piece of kitchen roll.
Seals
Check frequently to ensure that seals in the door and ash pan are intact and not brittle. Failing this, they
should be replaced. Use original seals only.
Surface
Usually, it is not necessary to any treatment to the painted surfaces of the wood-burning stove. Any damage
to the paint may, however, be remedied with spray paint, which can be bought from your stove retailer.
Guarantee
The guarantee does not cover damage due to insufficient maintenance!
To Next Page
Loading...
