What to do if HWASHIN Ultrasonic Jewelry Cleaner doesn’t start?
If your HWASHIN Ultrasonic Jewelry Cleaner doesn't start, here's what you can check: * Ensure the unit is properly plugged into the electrical outlet. * Make sure the power button is turned on. * If the fuse is faulty, replace it with a new one (located on the back of the unit/fuse box).
Why is ultrasonic activity decreased in my HWASHIN Jewelry Cleaner?
Decreased ultrasonic activity in your HWASHIN Jewelry Cleaner can occur due to several reasons: 1. The cleaning solution may be spent or dirty, so change the solution. 2. The solution level might be too low, add more solution. 3. The liquid level may be incorrect for the load, adjust the level with the load until activity increases. 4. The bath bottom may be covered with soil particles, clean the bath with warm water and a nonabrasive cloth. 5. The solution may not be degassed; ensure the bath was filled with water and has run for 5 minutes.
General| Brand | HWASHIN |
|---|---|
| Model | POWERSONIC 605 |
| Category | Ultrasonic Jewelry Cleaner |
| Language | English |
To Next Page
