OPERATING PROCEDURES
ROOM EXTEND PROCEDURE
1. Unlock all room-locking devices to include travel
the room remove it before extending the room.
WARNING:
extend the room.
3. To extend the room, press and hold the
ROOM CONTROL SWITCH in the "EXTEND" position
until the room is fully extended.
halt the operation of the room.
4. Turn the room control panel KEY SWITCH to
KEEP PEOPLE AND OBSTRUCTIONS
CLEAR OF ROOM WHEN OPERATING.
IMPORTANT: Do not use a room extension support
when the vehicle is supported by the leveling system.
NOTE: If a MANUAL RETRACT WINCH is attached to
NOTE: Make sure there is adequate clearance to fully
NOTE: Releasing the ROOM CONTROL SWITCH will
2. If equipped with a HWH room control panel, turn the
room control panel KEY SWITCH to the "ON" position.
after the room is fully extended or stops moving.
in the "EXTEND" position for more than ten seconds
of the room, do not reverse direction of the room until
after the room is fully extended. This assures proper
Hold the switch to "EXTEND" three or four seconds
pressurization of the cylinders.
Do not hold the ROOM CONTROL SWITCHIMPORTANT:
NOTE:
During normal operation
the room is fully extended. If necessary, the direction
of the room may be reversed, but watch for binding of
the room. If the direction of the room has been
reversed, DO NOT re-extend the room until the room
has been fully retracted.
If either side of the room stops moving, release the
room control switch immediately. DO NOT force the
room. DO NOT reverse direction of the room, contact
HWH Customer Service for assistance 1-800-321-3494.
MP34.431
06MAY1
the "OFF" position.
DISENGAGED BEFORE OPERATING THE ROOM.
RETRACTING DEVICES ARE DETACHED OR
ALL ROOM LOCKING, CLAMPING OR MANUAL
OPERATOR’S RESPONSIBILITY TO ENSURE THAT
PERSONAL INJURY AND VEHICLE DAMAGE. IT IS THE
DEVICES ATTACHED OR ENGAGED CAN CAUSE
ROOM LOCKING, CLAMPING OR MANUAL RETRACTING
WARNING: OPERATING A ROOM WITH ANY
clamps/locks supplied by manufacturers other than HWH.
NOTE: The park brake must be set to operate the rooms.
LEVEL IN/LEVEL OUT ROOM MECHANISMS
When the room is fully extended, the floor will raise into
position. Hold the Room Control Switch to the EXTEND
position until the floor is fully raised.
room extension and leveling system operation.
Refer to vehicle manufacturer for proper sequence of
To Next Page
Loading...