11
Clean area behind dryer as well as the back of the
dryer itself using the Lint Trap brush and a vacuum
a) Remove vent from the back of the dryer.
b) Hook-up a shop vac using the included
“Vacuum Adapter” or attach an electric leaf
blower to vent. Attachment can be made by
using a piece of duct tape.
c) Be sure that the outside vent hood is taped
open before turning vacuum on
!
Caution!
If vent compresses when the vacuum is turned on, turn vacuum
off immediately. This indicates a blockage or restriction in the
vent and should be checked by a professional.
Step10
Step9
To Next Page