HYC LintEater - Disconnecting the Rods; Inserting Rods into Drill Chuck; Attaching Brushes to Rods

4


 
 Holdendofrodverytightlybyhandorwithpliers
Option1

Usetwopairsofplierstoloosen&thenunscrewtherodsby
hand

Option2

Youcandisconnecteachrodusingthedrillaswell.
a. Holdtheendoftherod,whichisinsidethevent,very
tightly.
b. Reversethedrillwhileholdingtherodendtounscrew
therodwhichisconnectedtothedrill.
CAUTION!
Besurethattherodsthatarestillintheventdonotsp
inas
thiswillcausethemtodisconnectinsidethevent.






 
1. Thefittingsontherodsaredesignedtofitintoanytypeofdrill
withoutanadapter.


2. Simply insert thesteelrodfittingintothechuckofthedrilland
tightenbyhand

Twistchucktotighten





AugerBrush:

ScrewAugerBrushontoro dand tighten.Insertsetscrewinto
threadedholeinAugerBrushfittingandtightenusingincludedhexkey.
(Use8‐32x1/8”Lsetscrewifreplacementisneeded)

LintTrapBrush:
ScrewLintTrapBrushontorodthentightenwithtwopairsofpliers.
Useasmallpieceofducttapeonjointtohelpreducetheriskof
brushunscrewingfromrod.
ImportantNote:
OnlyusetheLintTrapBrushbyhand.
“DoNotUsetheDrilltoSpin.”Whilecleaningwi
ththebrushbyhand,
rotatetherodclockwisetoensurethatthebrushdoesnotloosen.

DisconnectingtheRods
InsertingRodsinto DrillChuck
AttachingBrushestoRods