What to do if my Hyco Heater is beeping due to an overheat event?
If your Hyco Heater experiences an overheat event, you'll hear a beeping sound. To stop the beeping, simply press any button on the appliance to clear the fault. It's important to investigate what caused the overheat in the first place.
What to do if my Hyco AC2000T shows an open window detection?
If your Hyco Heater detects an open window, resolve the cause of the open window detection. Then, switch the appliance off and back on using the on/off button to clear the alert.
Electrical installation must be by a qualified electrician per I.E.E. Wiring Regulations.
Connect unit only to single-phase supply with mains voltage specified on rating plate.
In bathrooms, ensure switches/controls are out of reach of persons in bath or shower.
WARNING: To avoid overheating, do not cover the heater.
Appliance can be used by children 8+ and persons with reduced capabilities if supervised.
Children under 3 years must be kept away unless continuously supervised.
Children 3-8 years can operate if supervised; cannot plug in, regulate, or clean.
CAUTION: Parts can become very hot and cause burns, especially with children present.
Select suitable location and maintain minimum spaces for good airflow and safe operation.
Guides for connecting the heater to the property's electrical system.
Allows user-defined schedules for up to four periods of operation each day.
Explains common error codes such as E1 (Temp Sensor) and E3 (Overheat).
General| Frequency | 50Hz |
|---|---|
| Motor | Yes |
| Heater Element | Ceramic |
| Adjustable Thermostat | Yes |
| Overheat Protection | Yes |
| Tip-over Protection | Yes |
| Oscillation | Yes |
| Construction | Plastic |
| Rating/Power | 2000W |
To Next Page
