Installation and maintenance manual
H.I.B Hydac International Page 20 of 36
Version: G/DV
Date: 11.01.2023
For Transport, appropriate tools must be used. Only use suitable and approved
hoists. Don’t step under suspended load. Wear safety shoes. Load-suspension
attachments may only be applied from a vertical line with an angle less than 30°.
Observe all relevant safety regulations without fail.
As a rule work on the electrical system must be carried out by expert personnel; the
valid wiring diagram ant the VDE guidelines must be observed.
For transport, observe the location of the centre of gravity
Wear safety boots during transport.
Transport of G7/G8 with traverse or forklift!
Transport of S7 with steel tube
(diameter 40 – 50mm) and with transport belts
To Next Page
Loading...
General