Need help?Do you have a question about the Hydra-Cell G-10 and is the answer not in the manual?
Presents performance curves showing flow rate versus RPM under various pressures.
Displays NPSHr curves for different pump models.
Outlines crucial safety and operational precautions for installation.
Guidelines for suction and pressure feed line installations and supply tank setup.
Explains NPSHa and its importance in preventing cavitation.
Offers guidance on discharge line selection, routing, and velocity.
Details the installation and adjustment of pressure regulators and relief valves.
Lists essential checks to perform before starting the pump.
Step-by-step instructions for safely starting the pump for the first time.
Provides instructions for protecting the pump during freezing conditions.
Details the procedure for inspecting and replacing pump diaphragms.
Guide for priming hydraulic cells on standard pump configurations.
Methods for priming hydraulic cells specifically for Kel-Cell pumps.
General| Maximum Pressure | 1000 PSI (69 bar) |
|---|---|
| Power Source | Electric |
| Motor Voltage | 230/460V |
| Inlet Port Size | 1 inch |
| Outlet Port Size | 1 inch |
| Maximum Fluid Temperature | 200°F (93°C) |
| Motor Phase | 3 Phase |
| Materials | Cast Iron, Stainless Steel |
To Next Page
