Hydreka HYDRINS 2 User Manual

CHANGES OF MODE AND POWER SUPPLY
OF THE HYDRINS 2 AND ITS DISPLAY
- Page 1 -
CHANGES OF MODE
AND
POWER SUPPLY
OF
THE HYDRINS 2
AND
ITS DISPLAY

Hydreka HYDRINS 2 Specifications

General

Protection	IP 68
Power supply	12 … 30 VDC
Output signal	4 … 20 mA
Communication	HART
Material	Stainless steel

Summary

I) HydrINS 2 : change of MODE (with or without display)

I.1) Tools

Lists necessary tools for HydrINS 2 mode changes.

I.2) Disassembling

Step-by-step guide to disassembling the probe head.

I.3) Change of MODE

Instructions for changing the device's operational mode using its switch.

I.4) Reassembling

Steps to reassemble the probe after completing mode changes.

II) Display : Lithium batteries to external power supply

II.1) External power supply with internal connection (6-28V)

How to configure for external power using internal connections.

II.2) External power supply with the military connector (6-28V)

How to configure for external power using the military connector.

III) Display : External power supply to lithium batteries

III.1) Configuration of switches SW1, SW2 et SW3

Configuration of switches for converting to lithium battery power.

IV) Display : External power supply for 4-20 mA output to lithium batteries for pulse output

IV.1) Disable the 4-20 mA function

Procedures to disable the 4-20 mA output function.

IV.2) Configuration of switches SW1, SW2 et SW3

Switch settings for 4-20 mA output to pulse output conversion.