Hydrofarm Autopilot APCEM User Manual

www.Hydrofarm.com 4
INSTRUCTIONS
USING THE MUTE FUNCTION
1. Press Mode. The speaker icon ashes simultaneously.
2. Press Enter, then press Up or Down to select on or o.
3. Press Enter again to save the data.
NOTE: The default (factory) seng for the alarm is o. Set the alarm on/o under MUTE funcon
as described above.
USING THE ALTI MODE:
1. Press Mode. The ALTI icon will ash.
2. Press Enter. ALTI will show on the display. Press the Mode buon to choose between m (meters)
and  (feet).
3. Adjust altude to match your locaon (step=100m/500) using the Up and Down buons.
4. Press Enter again to save the data.
SETTING THE ALARM 1 LEVEL
1. Press Mode. The ALARM 1 icon will ash.
2. Press Enter. Use Up/Down to set the parameter. The default ALARM 1 is 800 ppm.
3. Press Enter again to save the data.
NOTE: When CO
2
Alarm level is ≥1,000 ppm, the interval is ±100ppm, and when the CO
2
Alarm level is
˂1,000 ppm, the interval is ±50 ppm. Aer seng a new alarm level parameter, the green LED will light
when CO
2
concentraon is below the Alarm 1 level.

Hydrofarm Autopilot APCEM Specifications

General

Brand	Hydrofarm
Model	Autopilot APCEM
Category	Monitor
Language	English