English
s38 USER GUIDE
LOCATION
For optimal performance, install the unit on the cold feed to the place where the water is
heated. This could be on the cold inlet to an instant water heater (A) or on the cold inlet to
a hot water cylinder (B).
INSTALLATION
• Wrap the clip around the pipe and tighten the screw with a screwdriver (C).
• Push the top section rmly onto the clip (D).
• Slide the bottom section onto the top section (E).
• Withdraw the split pin (F).
• Plug PSU into unit and connect to mains power (G).
Note: the unit can be tted without a clip when the pipe is close to the wall.
ELECTRICITY
As with all electrical equipment, ensure that the equipment is connected in accordance with
current electrical regulations in your area.
TROUBLESHOOTING
The red light shows that the signal is being transmitted into the water - it should be bright.
If this is not the case check the following:
• The split pin should be removed from the unit.
• The mains supply should be on. Check that the PSU is fully plugged into the mains and
that the DC jack is fully plugged into the unit.
• If tting to metal pipework, avoid placing unit into an electrical loop (see below).
If the unit is tted in a loop, move the unit to a location outside the loop.
0102
To Next Page
Loading...
