To Next PageTo Next Page
Need help?Do you have a question about the Hydromatic S4NX and is the answer not in the manual?
General| Brand | Hydromatic |
|---|---|
| Model | S4NX |
| Category | Water Pump |
| Language | English |
Details the hazardous location submersible pump's design and service requirements.
Provides guidance on manual impeller rotation for pumps in storage or not operating for extended periods.
Explains the function of two moisture detectors in the seal chamber for leak detection.
Describes the function of motor heat sensors and their role in preventing overheating.
Details power cord connections, grounding, and inspection requirements.
Specifies requirements for overload relays and heater sizing for 3-phase pumps.
Explains the setting of lower and turn-on float controls for sump level management.
Provides instructions for preparing and installing the pump in a sump, including impeller checks.
Emphasizes following local codes and using qualified electricians for wiring.
Details connections for heat sensors and seal failure probes in control panels.
Outlines the step-by-step procedure for safely starting the pump system.
Details sequence of operation for multiple pumps and checks during operation.
States motors are oil-filled, require no lubrication, but periodic checks for corrosion/wear are needed.
Step-by-step guide for removing and replacing the pump stator, including important connection notes.
Details the process for replacing pump seals and bearings, emphasizing new parts and proper assembly.
Wiring diagram for 230 Volt single-phase connections.
Wiring diagram for 200 or 575 Volt three-phase connections.
Wiring diagram for 230 Volt three-phase connections.
Wiring diagram for 460 Volt three-phase connections.
Details required information for ordering replacement parts, including serial and part numbers.
Lists all available pump components with their respective part numbers and descriptions.
Details the 12/18 month warranty period, conditions, and exclusions.
Outlines limitations and disclaimers, including installation and misuse, and liability for damages.
Section for recording details about the pump system, including well and liquid characteristics.
Section for noting electrical specifications like panel ratings, voltages, and component hookups.
Section for documenting pump type, serial number, impeller size, and operational data.
Section for customer and technician to acknowledge accuracy and proper procedures.
