How to fix cloudy water in my Hydropool Serenity Hot Tubs?
Cloudy water in your Hydropool Hot Tub is often due to microscopic particles that are too small for the filter to catch. To resolve this, test and adjust all water balance elements. You can add a flocculent to help these particles combine so they can be filtered out. Also, consider increasing the filter cycle time.
What to do if I have skin or eye irritation from my Hydropool Serenity Hot Tubs Hot Tub?
Skin or eye irritation from your Hydropool Hot Tub is often caused by improper pH and/or total alkalinity levels. Test the water balance and make the appropriate changes to correct these levels.
Why is the pH in my Hydropool Hot Tub unstable?
An unstable pH in your Hydropool Hot Tub is often due to low total alkalinity levels. Test the total alkalinity levels and, if necessary, increase them with sodium bicarbonate.
Why is the pH in my Hydropool Hot Tub resistant to changing?
If the pH in your Hydropool Hot Tub is resistant to changing, it's likely due to high total alkalinity levels. Test the total alkalinity levels and, if necessary, decrease them with sodium bisulfate or muriatic acid.
How to remove scale (white/grayish deposit) from my Hydropool Serenity Hot Tubs?
Scale, a white or grayish deposit in your Hydropool Hot Tub, is often caused by high calcium hardness. Test the calcium hardness level and treat it with a sequestering agent or perform a partial drain and refill.
What causes discolored water in my Hydropool Hot Tub?
Discolored water in your Hydropool Hot Tub is often caused by the presence of metals in the water, such as iron or copper. Treat the water with a chelating or sequestering agent.
General safety warnings and precautions for hot tub use.
Information on the risks and symptoms of overheating.
Factors to consider when selecting an indoor installation site.
Essential safety guidelines for electrical installation.
Guide for applying GFCI/RCD protection for various models.
Typical GFCI installation diagram for North America.
Typical RCD installation diagram for Europe.
Procedures for filling, checking for leaks, and starting the hot tub.
Steps to prime the pump and release air locks.
Why maintaining water quality is crucial for equipment longevity.
Chart outlining ideal chemical levels for hot tub water.
How to clean and replace the cartridge filter.
Step-by-step instructions for draining the hot tub.
Step-by-step guide for winterizing the hot tub.
Explains overheat messages and actions to take.
Explains sensor error messages and troubleshooting.
Explains flow and pressure related error messages.
Troubleshooting common electrical and mechanical problems.
Troubleshooting water balance and power supply problems.
To Next Page
General