Hydropool SS13FFPAP - Page 33

33
If you need to replace a transmier or pair your transmiers again, power up the home
transmier and press on its pairing buon with a paper clip. The status light of the transmier
will blink yellow.
Then, shut off the spa’s breaker to turn the spa transmier off. Wait a lile and put the
breaker back on. Within a few seconds, pairing will be completed and both transmier status
lights will turn to blue.
4. Transmiers status LED indicator
Both the home and spa transmiers have color status LED that can be used for
troubleshoong purposes
.
When the LED status is blinking (blue, green or red) this indicates that the communicaon between the EN
module and the CO module it not established.