Hydropool SS14ES - Gecko IN.YE3 Control System

21
HYDROPOOL SWIMSPA AQUAPLAY SERIES CONTROL SYSTEMS GECKO IN.YE3
NORTH AMERICA / EUROPE
PROGRAMMING THE
FILTER / PURGE CYCLES
The filter cycle menu consists of the
following parameter: the start me (FS), the
duraon (Fd), and the frequency (FF).
NOTE: A filter cycle consists of starng all the
pumps and blower (if equipped) in high speed
for 1 minute (purge step) then the pump
associated with the filter cycle will run in low
speed for the remaining duraon of the filter
cycle (clean up step).
SETTING THE FILTER CYCLE
Aer you have programmed the clock, the next
parameter is the filter cycle start me. The
display will show FSxx, with “xx” represenng
the starng hour of the cycle. Use the arrow
keys to adjust the hours. Use the Light Key to
jump to the next parameter, filter duraon
(Fd).
The display will show Fdxx, with “xx”
represenng the duraon in hours of the filter
cycle. Use the arrow keys to adjust the
duraon. Use the Light Key to jump to the next
parameter, filter frequency (FF).
The display will show FFxx, with “xx”
represenng the number of cycles per day.
Use the arrow keys to adjust the frequency.
Use the Light Key to jump to the next
parameter, economy mode (EP)
This mode allows you to lower the
temperature set point of the spa by 20F (11C)
during a certain period of the day.
The display will show Epx, with “x”
represenng the state of the programming (0
= disabled, 1 = enabled). Use the arrow keys
to enable or disable the economy mode. Use
the light key to jump to the next parameter,
economy start me (ES).
When the Economy mode in ON, the display
will toggle between the “Eco” message, the
me and the water temperature.