Hydropool SS14ET - Standby Mode; Drain Mode

42
STANDBY MODE
A press of the SETTINGS icon and scroll to the MAINTENANCE menu opons. Press the MAINTENANCE icon to
display the STANDBY icon. Press the STANDBY icon and the following message will appear.
“All pumps off! Press Cancel to exit Standby mode or Drain to drain spa”
This mode allows you to stop all outputs including all automac funcons such as a filter cycle, heang requests
and smart winter mode purging for 30 minutes to perform quick spa maintenance.
DRAIN MODE
If you wish to put your spa into “DRAIN MODE” follow the instrucons above for pung the spa into “STANDBY
MODE” and then press DRAIN on the display. Once you do that the display will indicate “Drain in progress”. The
filtraon pump will turn on and run for 60 minutes.
In order to exit this mode, press CANCEL to exit DRAIN MODE. This will put you back into STANDBY MODE and if
you wish to exit that press the same key to go back to the main screen.