48 Wet Cleaning of Upholstery Spraying 49
WET CLEANING OF UPHOLSTERY SPRAYING
• Connect the upholstery nozzle to the NIMBUS Hose Handle and insert the NIMBUS spray
nozzle into the valve.
• Turn on the main switch and pull the valve trigger to start the water ow.
• Wash upholstery by moving the nozzle back and forth with the upholstery nozzle held at
an angle allowing clearance of front edge from the upholstery surface. Do not soak the
upholstery!
• Release the valve trigger and dry the cleaned upholstery by moving the nozzle backward
with the upholstery nozzle held at an angle allowing direct contact of front edge with
the upholstery surface.
• Use caution during wet cleaning so you do not exceed maximum level in the water pan.
• Insert the NIMBUS spray nozzle into the valve.
• Turn on the main switch and pull the valve trigger to start the water ow.
• Use the water spray to wash or wet surfaces.
• Release the valve trigger to stop the water. Suction of water is possible if necessary.
To Next Page
Loading...
