HYLA GST - Wet Cleaning Procedures for Floors and Upholstery

46 Wet Cleaning of Hard Floors Wet Cleaning of Carpeted Floors 47
WET CLEANING OF CARPETED FLOORSWET CLEANING OF HARD FLOORS
• Connect the fresh-water tube to the hard oor nozzle.
• Turn on the main switch and pull the valve trigger to start the water ow.
• Clean the oor by moving the nozzle back and forth with the suction device held at an angle
allowing for clearance of the squeegee strip from oor.
• Release the valve trigger and dry the cleaned oor by moving the nozzle backwards with
the suction device held at an angle allowing direct contact of the squeegee strip with the oor.
• Use caution during wet cleaning so you do not exceed maximum level in the water pan.
WARNING! Wet oors may be slippery!
• Connect the fresh water tube to the carpet nozzle.
• Turn on the main switch and pull the valve trigger to start the water ow.
• Wash the carpet by moving the nozzle back and forth with the suction device held at an
angle allowing clearance of front edge from the carpet. Do not soak the carpet!
• Release the valve trigger and dry the cleaned carpet by moving the nozzle backwards with
the suction device held at an angle allowing direct contact of front edge with the carpet.
• Use caution during wet cleaning so you do not exceed maximum level in the water pan.