To Next PageTo Next Page
Need help?Do you have a question about the HYPE FOX and is the answer not in the manual?
Distinguishes between 'Almost Ready To Fly' and 'Ready To Fly' versions.
Details key technical data like wingspan, length, weight, and scale.
Lists the controllable functions of the remote control system.
Identifies and describes the controls and features of the ST6DF transmitter.
Explains the receiver unit, its connections, and indicator lights.
Instructions for installing batteries into the transmitter unit.
Guidance on positioning the receiver antenna for optimal signal.
Provides instructions on operating the radio system and transmitter antenna positioning.
Step-by-step guide to bind the transmitter and receiver components.
Explains how to change stick modes and illustrates different control layouts.
Instructions on connecting and charging the LiPo battery using the provided charger.
Details how to connect the charger to a 12V power source like a car cigarette lighter.
Crucial safety advice regarding battery cooling, charging, and handling.
Instructions on connecting the elevator linkage to the elevator horn.
Details on inserting the wing joiner into the carbon tube for the wing.
Steps for mounting and securing the horizontal stabilizer to the fuselage.
Guidance on connecting the aileron servo cables to the receiver unit.
Steps for tightening screws to lock the wing halves securely.
Instructions for positioning the receiver antenna out of the fuselage.
Steps for placing the LiPo battery into the front part of the fuselage.
Setting the maximum travel for control surfaces like ailerons, rudder, and elevator.
Steps for placing the canopy onto the front part of the fuselage.
Verifying correct movement of all control surfaces and functions.
Instructions for checking and adjusting the model's center of gravity.
Procedure to check and verify the correct direction of movement for all control surfaces.
Checking the motor's response to throttle stick movements.
Instructions and tips for safely taking off the model.
Step-by-step guide for performing a safe landing of the model.
General safety advice for electric models, including age, assembly, and operating location.
Safety measures during operation, like stopping on malfunction, handling hot parts, and maintenance.
Safety regarding battery handling, charging, cable management, and electronic component protection.
Details CE certification and provides contact information for technical questions.
General information and warnings about Lithium-Polymer (LiPo) batteries.
Specific instructions and warnings for charging LiPo batteries safely.
Guidelines and warnings for discharging LiPo batteries correctly.
Instructions regarding damage to the battery casing, foil, and identification of damaged cells.
Covers general warnings, warranty exclusion, and liability disclaimer for batteries.
List of available spare parts with item numbers and descriptions.
Declaration of warranty terms and conditions for Hype products.
Details on parts and conditions not covered by the warranty.
Information on customer's statutory rights concerning product defects.
Specifies the warranty duration and the procedure for asserting claims.
Declares the product type and its intended use in RC model building.
Details compliance with health and safety requirements as per Article 3.1.a.
Details compliance with electromagnetic compatibility requirements as per Article 3.1.b.
Details measures for efficient use of the radio frequency spectrum as per Article 3.2.
General