Hypertherm EDGE Pro CNCs User Manual

EDGE Pro CNC Field Service Bulletin 808110 Revision 1 7
Wireless networking for EDGE Pro CNCs
5. Load the driver as follows:
a. Press ALT+F4 to exit Phoenix.
b. Click the Windows Start icon (or the Windows key on the keyboard).
c. Choose Windows Explorer > My Computer.
d. Choose USB disk (E:).
Note: Your drive letter may vary. Be sure to choose the USB disk.
e. Locate and double-click on the 081333.exe file.
f. Follow the prompts to install the driver.
g. Wait for the pop-up message that states “Install shield wizard complete” and then click finish.
h. Restart the CNC for the driver to take effect.

Hypertherm EDGE Pro CNCs Specifications

General

Brand	Hypertherm
Model	EDGE Pro CNCs
Category	Controller
Language	English