Need help?Do you have a question about the Hypertherm EDGE Pro CNCs and is the answer not in the manual?
General| Connectivity | Ethernet, USB |
|---|---|
| Display | Touchscreen display |
| Operating System | Windows-based |
| Hard Drive | Solid State Drive (SSD) |
| User Interface | Touchscreen |
| Supported File Formats | .DXF, .DWG, .NC |
| Plasma System Compatibility | Hypertherm plasma systems |
| Motion Control | Precision motion control |
| Programming Features | Nesting |
| Safety Features | Emergency stop, Safety interlocks |
Introduces the purpose of wireless networking for EDGE Pro CNCs and the kit covered.
Step-by-step instructions for physically installing the wireless network adapter into the CNC motherboard.
Details the process of mounting antennas and routing their extension cables onto the CNC enclosure.
Instructions on loading and installing the wireless network card drivers from the provided USB flash drive.
Steps to confirm the wireless network connection is recognized and functional within the Windows operating system.
Guidance on disabling unnecessary network adapters to prevent potential connection delays.
Instructions on how to map a network drive in Windows for defining network folders in Phoenix.
Details the process of adding a mapped network drive as a folder within the Phoenix software.
Provides common issues and solutions for problems encountered while using the wireless network on the CNC.
To Next Page
