EDGE Pro CNC Field Service Bulletin 808110 Revision 1 9
Wireless networking for EDGE Pro CNCs
Disabling unused network connections
If you have a wired network that is set up for automatic configuration but is not connected, you must disable the adapter
for this network to prevent connection delays for the CNC.
NOTE: If you have a Hypernet connection, DO NOT disable it. Hypernet is used to communicate with a plasma
system or the ArcGlide THC, but not with other computers on a network.
1. Press Alt+F4 to exit Phoenix.
2. Choose Start > Settings > Network Connections.
3. Right-click a network adapter that is not being used and choose Status. The status window for the adapter opens.
4. Choose Disable, then Close to disable the network adapter.
To Next Page
Loading...