Diagram 10 (a)
Diagram 10 (c)
Diagram 10 (b)
Diagram 10 (d)
The Installation Procedure
Hypervolt Limited, Unit 17, Innovation Business Centre, Rainham, RM13 8HZ, UK 10
Revision 1. Issue date: Feb. 2020
6. Finishing Off
Insert the LED panel back into its location. Ensure it clicks
properly into place and it is not miss-alignned. Lastly, place
the top cover back onto the unit and secure using the 4
off screws. Take care to avoid cross-threading during this
process, as the water-tightness of the unit and its seals rely
on these 4 screws being into place.
To Previous Page
Loading...
