HyperX FURY DDR4 User Manual (English)

To Next Page

FURY DDR4

Installation Manual

Desktop DIMM Installation

Note: Never apply pressure or handle the memory module on or around the Integrated Circuit

(IC)! Always handle the memory with both hands positioned at the upper-most corners of the

Printed Circuit Board (PCB).

1) Disconnect the AC power cord and remove the computer cover.

2) Prior to handling the memory module(s), always touch an unpainted and earthed metal object

or use an earthed antistatic wrist strap to prevent electrostatic discharge (ESD).

3) If necessary, remove pre-existing memory by pressing down on the lock/ejector tabs. The tabs

are located at both ends of the memory socket.

Need help?

Do you have a question about the HyperX FURY DDR4 and is the answer not in the manual?

HyperX FURY DDR4 Specifications

General

Disconnect the computer's AC power cord and remove the casing.

Ground yourself by touching metal or wearing an antistatic wrist strap before handling modules.

Press lock/ejector tabs on both ends of the socket to release existing memory.

Match the memory module's notch with the socket's key for proper alignment.

Insert the memory module into the socket until retention tabs click into place.

Replace the computer cover and reconnect the AC power cord.

Disconnect AC power and remove the notebook battery before proceeding.

Ground yourself by touching metal or wearing an antistatic wrist strap before handling modules.

Gently pull lock/ejector tabs away from the SO-DIMM socket to release memory.

Align the SO-DIMM notch with the socket key and insert at a 30-degree angle.

Rotate the SO-DIMM downwards until the lock/ejector tabs engage and secure it.

Replace the notebook battery and reconnect the AC power cord.