Need help?Do you have a question about the Hyster H3.20XM and is the answer not in the manual?
Explains the meaning of WARNING and CAUTION symbols and text in the manual.
Procedures for inspecting and repairing cylinder head, camshaft, valve guides, seats, valves, and springs.
Steps for removing crankshaft and inspecting journals, bearings, and oil passages.
Checking cylinder block surface for distortion and cylinder bores for wear.
Inspecting and assembling the oil pump components.
Procedure for adjusting intake and exhaust valve clearances when the engine is hot.
Steps for checking engine compression using a gauge and identifying potential issues.
Correct timing settings for gasoline and LPG engines based on model.
Possible causes and procedures for an engine that will not start.
Troubleshooting steps for rough running, lack of power, and engine noise.
Troubleshooting for engine overheating, leaks, and other common problems.
To Next Page
General