Need help?Do you have a question about the Hyster H70XM and is the answer not in the manual?
Describes the forklift frame as a one-piece weldment with mounts for major components like the engine and axles.
Details the removal and installation of the counterweight, including crucial safety warnings and weight specifications.
Procedure for removing the lift truck hood, emphasizing safe blocking and disconnection of gas-assist cylinders and wiring.
Steps to install the lift truck hood, including reconnecting gas-assist cylinders, wiring, and securing hinges with pins.
Instructions for removing the overhead guard, requiring lifting devices and disconnection of capscrews from frame and cowl.
Procedure to inspect the condition of mount isolators at the rear legs of the overhead guard for any damage.
Steps for installing the overhead guard, including positioning, connecting lifting devices, and tightening capscrews.
Guidance on replacing non-repairable LED light assemblies, noting they must be replaced as a complete unit.
Steps for removing the radiator, including draining coolant, disconnecting hoses, and removing support plates and reservoir.
Instructions for installing the radiator, including connecting hoses, installing support plates, and filling the cooling system.
Procedures for removing and installing the muffler, involving counterweight and exhaust pipe disconnection and reconnection.
Steps for removing and installing LPG/GAS engine exhaust pipes for trucks without low emissions.
Steps for removing the EPA compliant LPG/GAS exhaust system, including counterweight and pipe disconnections.
Instructions for installing the EPA compliant LPG/GAS exhaust system, including oxygen sensor service and pipe connections.
Steps for removing the diesel engine exhaust pipe, involving counterweight, muffler, and engine manifold disconnections.
Instructions for installing the diesel engine exhaust pipe, including connecting manifold pipes and heat shields.
Detailed steps for engine removal, covering disconnection of battery, fuel, throttle, hydraulic, and exhaust systems, and support.
Instructions for engine installation, including connecting exhaust, fuel, hydraulic, and electrical systems, and mounting hardware.
To Next Page
General