Need help?Do you have a question about the Hyster H25XM and is the answer not in the manual?
Check bottom surface of cylinder head for distortion and measure for wear.
Measure camshaft lobe height, journal diameter, and check for straightness.
Inspect crankshaft for wear, cracks, measure journal diameter and straightness.
Inspect main bearings for damage and measure clearance with crankshaft.
Steps to remove and disassemble the oil pump components.
Measure clearances between oil pump gears, housing, and check for wear.
Assemble the oil pump, including gears, cover, and plunger.
Adjust intake and exhaust valve clearances when the engine is hot.
Install compression gauge and crank engine to measure cylinder pressure.
Check and adjust engine timing based on specified conditions.
Troubleshooting steps for an engine that fails to start.
Lists possible causes and procedures when the engine lacks power.
Lists possible causes and procedures for unusual noise within the engine.
Lists possible causes and procedures when the engine overheats.
To Next Page
General