Need help?Do you have a question about the Hyster H2.00XM and is the answer not in the manual?
Inspects main bearings for damage and measures clearance between bearings and crankshaft.
Steps for removing pistons and connecting rods from the block and disassembling them.
Inspects pistons for wear and cracks, measures piston diameter and clearance.
Procedures for assembling pistons, connecting rods, and installing them into the engine.
Procedures for disassembling the oil pump assembly.
Instructions for cleaning oil pump components.
Inspects oil pump housing, cover, and gears for wear or damage.
Procedures for assembling the oil pump components.
Steps for installing the water pump assembly and related components.
Steps to remove the flywheel and flange.
Procedures for installing the flywheel and related components.
Steps to adjust intake and exhaust valve clearances for engine operation.
Steps for installing gauge, cranking engine, and reading pressure.
Torque settings for camshaft pulley, cooling fan, cylinder head, etc.
To Next Page
General