Hytera HP50X - Troubleshooting

Troubleshooting
User Manual
22
10. Troubleshooting
Phenomena
Analysis
Solution
The radio cannot be turned
on.
The battery may be installed improperly.
Remove and reattach the battery.
The battery power may have run out.
Recharge or replace the battery.
The battery may suffer from poor
contact caused by dirtied or damaged
battery contacts.
Clean the battery contacts.
The voice is unclear.
The signal may be weak.
Make sure call participants are within the
communication range.
There are unknown voices or
sounds on the channel.
You may be interrupted by radios using
the same frequency.
Change the frequency, or adjust the squelch
level.
The radio may be set with no signaling.
Set signaling for all member radios to
avoid interference at the same frequency.
The radio cannot be located.
The radio may be at an unfavorable
position, so no GPS signal is received.
Move to an open and flat area, and try
again.
The radio cannot pair with the
BT device.
The battery power of the BT device may
be low.
Recharge the BT device.
The BT device may be too far away
from the radio.
Move the BT device towards the radio.
During receiving, the voice is
weak, discontinuous, or
totally inactive.
The battery voltage may be low.
Recharge or replace the battery.
The volume may be low.
Increase the volume.
The antenna may be loosened or
installed improperly.
Turn the radio off, and then remove and
reattach the antenna.