12
Features and Operations
Operation
●
Go to “Menu -> Scan -> Scan On” to enable the Scan feature.
●
In the home screen, you can press the programmed Scan key to
enable the Scan feature, or switch to a channel on which the Auto
Scan feature is enabled via the CPS to enable the Scan feature.
After the feature is enabled, the radio will scan all the channels in the
scan list set for the channel on which scanning starts. The scanning
process is as follows:
1. During scanning, the radio displays the icon
, and the LED
indicator ashes orange slowly.
2. When activities are detected on a channel, the radio will stay on the
channel to receive current activities, and the LED indicator will glow
green.
If the radio stays on a non-priority channel, the radio will display the
icon
.If the radio stays on Priority Channel 1 or Priority Channel 2,
it will display the icon
or respectively.
3. If you don’t want to listen to the activities on the channel, press
the programmed Nuisance Temporary Delete key to remove the
channel from the scan list temporarily. The removed channel will not
be scanned in subsequent scanning, but it will be restored into the
scan list when the radio is restarted
4. If you want to keep listening to the activities on the channel, press
Note
the programmed Monitor key during
scan stay.
The radio cannot scan analog channel and digital
channel at the same time.
Deactivating the Scan feature
Description
With the Scan feature disabled, the radio will stop scanning all the
channels in the scan list set for the current channel.
Operation
●
Go to “Menu -> Scan -> Scan Off” to disable the Scan feature.
●
Press the programmed Scan key during scanning.
Setting the Scan List
Description
Scan List allows you to select the appropriate scan list.
Operation
Go to “Menu -> Scan -> Scan List” to select the appropriate scan list.
The radio can support up to 8 scan lists.
Setting the Radio
You can optimize performance of your radio via the following
conguration according to your actual needs and preferences.
To Next Page
Loading...
