Hytera PNC370 - Product Overview; Product Layout; Key Functions

Service Manual
Disassembly and Reassembly
3
a. Use a T8 screwdriver to remove the four screws on the chassis.
b. Use a tweezer to remove the FPC connector between the chassis and main board.
c. Remove the chassis.
5. Remove the main board as follows:
a. Use a Phillips screwdriver to remove the four screws on the main board.
b. Remove the four FPC connectors on the main board.
c. Remove the main board.
6. Use the needle-nose pliers to straighten the four clips and remove the screen holder and screen.