43.
EN
10. GLOSSARY
AC socket- The receptacle for the device plug used for AC applica-
tion
AC Circuit Protector- It protects AC circuits from being damaged
due to overload or short circuit by stopping the ow of electricity
between the generator and device.
Air Filter- It removes dust from engine intake air.
Carburetor- A device used to properly mix fuel and air in the cor-
rect proportions and delivering the mixture into the engine’s com-
bustion chamber.
Choke Rocker- It is used to provide proper starting mixture when
the engine is cold. The choke lever must be pulled out to ON posi-
tion when starting a cold engine.
DC Breaker Switch- It protects DC circuits from being damaged
due to overload or short circuit by stopping the ow of electricity
between the generator and device.
DC socket- the receptacle used for charging a 12 V battery
Dipstick- It seals off engine oil ll hole and is used for indicating the
engine oil level.
Drain Plug- A plug that can be removed to allow the uid contents
of the engine to be drained off.
ECON Switch- It is used for automatically reducing engine speed
when all loads are turned off or disconnected. If high electrical
loads are connected simultaneously, turn the ECON switch to OFF
position to reduce voltage changes. When using the DC output,
turn the ECON switch to OFF position.
ON position: To minimize fuel consumption and further reduce
noise levels when no load is applied
OFF position: The ECON system does not operate
Fuel Switch- It controls ow of fuel from fuel tank to carburetor.
Ground Terminal - It connects generator to ground wire for ground-
ing protection.
Oil Indicator light- Before the oil level falls below a safe limit, the
Oil Indicator light (red) will go ON and the Oil Alert system will auto-
matically stop the engine.
To Next Page
Loading...
Need help?
General
