Hyundai HYMT5080 User Manual

7.9.2 To sharpen the place the chain bar into a vice
(protect the bar from damage by the use vice
packing).
7.9.3 Sharpen as shown.
7.9.4 After every cutter has been set, check with the
depth gauge and file to the proper level as
illustrated.
1 – Gauge
checker
2 – Round the
shoulder
3 – Depth
gauge standard
Make sure to round off the front edge to
reduce the chance of kickback or tie-strap breakage.
7.9.5 Make sure every cutter has the
same length and edge angles as
illustrated.
8 STORING THE MACHINE
If you do not follow these steps, deposit may arise in the carburetor.
This will cause starting difficulties and may cause permanent
damage
8.1. Perform all the general maintenance that the maintenance section of your ‘User
Manual’ is recommended.
8.2. Clean the outside of the machine, drive axle, shield and nylon cutting head.
8.3. Remove all fuel from the fuel tank.
8.4. After all the fuel is drained, start the engine.
8.5. Allow the engine to run in idle until engine stops alone. This allows the fuel to be
removed from the carburetor.
8.6. Allow engine to cool down (about 5 minutes).
8.7. Use a spark plug wrench, remove the spark plug.
8.8. Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Slowly pull the
starter rope several times to coat internal components. Replace the spark plug.
Page 28

Hyundai HYMT5080 Specifications

General

Engine Type	Single cylinder, 2 strokes, air-cooled engine, 1E43F-B
Engine size - cc	50.8CC
Start method	Recoil
Fuel tank capacity - ml	800ML
Fuel ratio/fuel type	40:1 Semi-Synthetic 2-Stroke oil/unleaded petrol
Noise Level - dB	117
Rated power - kw	1.56kw
Rated speed - rpm	7500 rpm
Cutter head - mm	400-450
Head Line diameter - mm x length - m	2.4 x 4
Cutter blade mm/teeth	1.6mm/3T
Cutting Width - mm/length - mm/ diameter - mm	255mm for cutter blade / 400-450 for cutter head
Chainsaw bar length – inches (mm)	12 (300)
Hedge Trimmer Blade length – inches (mm)	18 (450)
Clutch type	Centrifugal type

Weight and Dimensions

Gross weight - kg	14.50
Dry weight - kg	12.50
Box Dimensions - L x W x H - mm	1070 x 280 x 300
Chainsaw total length – mm	3270 (with extension pole)
Hedge Trimmer total length – mm	3440 (with extension pole)
Brush cutter total length – mm	1860