EN - 23
EN
POWER SOURCE
Insert the adaptor plug into the DC IN jack on the rear of the unit, then connect
the AC/DC adaptor (DC 12V, 1A / AC100-240V, 50-60 Hz) to AC wall outlet.
UNPACKING THE TURNTABLE
1. Carefully remove unit from it‘s package and take it out of the plastic bag.
2. Open lid and remove black tie-wrap by untwisting and gently sliding out from under TONE
ARM (2).
3. Remove white protective needle cover by gently pulling towards front of unit.
TURNTABLE OPERATION
1. Power on the unit by turning the volume control knob clockwise
position. The power indicator (5) at the front of the unit will light up.
2. Turn the FUNCTION SWITCH (2) to PH/AUX mode.
3. Move the SPEED CONTROL SWITCH (21) to the desired speed, select from 33, 45 or 78
rpm. Place the record on the turntable (18) (use the spindle adaptor if required - 19).
4. Adjust the VOLUME CONTROL (4) and set this at mid range.
5. Use a nger to raise the tone arm (20) off its rest. Move the tone arm over the record and
gently release the tone arm to the point where you want to play the record.
6. Adjust the VOLUME CONTROL KNOB (4) to your desired sound level.
7. When AUTO STOP (15) is on ON position, after playing nished, the TONE ARM (20) will
stop automatically at the center.
When AUTO STOP (15) is on OFF position, after playing nished, the TONE ARM (20) will
not stop automatically and it will keep in the center of the disk unless turning off the device
or switch other function.
Note: If you nd the disk can not be nished the playing completely on ON position of AUTO
STOP (15), please turn to OFF position of AUTO STOP (15), then the disk will be nished at
the end.
RADIO OPERATION
1. Power on the unit by turning the volume control knob clockwise
position. The power indicator (5) at the front of the unit will light up.
2. Turn the Function Switch (2) to AM or FM mode.
3. Turn the TUNING KNOB (12) to select your desired position.
4. Adjust the VOLUM CONTROL KNOB (4) to your desired sound level.
FUNCTION AND OPERATION FOR USB
1. 1. STOP
When playing or pausing, press STOP, it will enter stop mode. When recording, press STOP
button, the recording will be finished.
2. PLAY/PAUSE
The unit is in play mode as default. Insert the USB flash into the USB port. Insert the USB
flash into the USB Port, press PLAY/PAUSE button during stop, the unit will be in play mode;
Press PLAY/PAUSE button during playing, the unit will be in pause mode; Press PLAY/
PAUSE button during pausing, the unit will be in play mode.
3. NEXT & BACK
Press NEXT button to the next song. Press BACK button to reverse to the previous song.
Press and hold the NEXT or BACK button for fast forward and rewind respectively.
4. RECORD
Press RECORD button once to start recording function, the LED indicator of RECORD/
ERASE will be on. Press STOP button to stop the recording, the LED indicator of RECORD/
ERASE will be off. During recording, the buttons are invalid except STOP.
To Next Page
Loading...