429
Features of your vehicle
To operate Compass feature
Press and release the button, then the
vehicle's directional heading will be dis-
played. Pressing and releasing the button
again will turn off the display.
Heading display
- E : East
- W : West
- S : South
- N : North
ex) NE : North East
Calibration procedure
The compass may not indicate the cor-
rect compass direction if the electronic
compass has not been calibrated cor-
rectly, if the compass zone number is dif-
ferent from your current location, or when
you are driving in certain areas (tunnel,
parking garage, underground parking lot,
near transformer substation, etc.), and
the following may occur:
- “C” is displayed.
- The compass headings become inac-
curate.
- The compass heading does not
change when the vehicle changes
direction.
- Some compass headings are not dis-
played.
- The compass headings are inaccurate
in long distance driving.
If the vehicle’s compass headings
become inaccurate, the compass should
be calibrated as follows:
1.Ensure the vehicle is not located near
large steel structures or under electric
power lines.
2.Turn on the compass by pressing the
button.
3.Press and hold the button for more
than 6 but less than 9 seconds. The
current zone number will appear in the
display. Release then press the button
until your zone number appears in the
display.
4.Check the mirror angle by pressing
and holding the button for more than
12seconds. Release then press the
button to “L”(for steering wheel on the
Left side of the vehicle). (if installed)
5.Press and hold the button between 9
and 12 seconds. Release the button
when a “C” appears in the display.
6.Drive the vehicle in 2 complete circles
at less than 5mph(8km/h) or until the
compass heading appears.
CAUTION
Be sure the area is free of traffic,
pedestrians, and obstructions.
To Next Page
Loading...
Need help?
General
