i-milk V1 Operating Manual July 2018
13
To Clean the Milk Filter Housing
Monthly Milk Filter Cleaning
i-milk has a milk filter located on the font outlet. This black
fitting delivers a uniform, steady, non-turbulent stream of
milk. If the filter mesh becomes blocked it may cause the
milk to squirt or froth.
To remove the milk filter rotate it as you pull it down.
If debris has collected on the visible lter mesh carefully reverse ush it.
Replace the lter into the font rotating it as you push it in place and test the milk ow.
If the milk ow is still not satisfactory carry out the monthly cleaning process outlined below.
As shown in the picture below, the lter is made up of
4 stainless steel mesh lters each separated by 1 of 3
smaller “O” Rings. The must be in this sequence.
To disassemble gently push the
lters and “O” Rings out of the
lter housing into a large bowl
so as not to lose any parts.
1 black lter housing
4 identical stainless steel mesh lters
3 smaller “O” Rings that separate each mesh lter.
These drop freely into the black lter housing.
1 larger “O” ring that is inserted last. It needs to be
pushed in place as it holds the mesh assembly in
the lter housing.
Technical Adjustments
7
To Next Page
Loading...