i-onik BTH-033 - Getting Started with Your Headset; Powering the Headset On and Off; Pairing the Headset with Bluetooth Devices

24 25
The charging procedure is as follows:
Using a USB cable
1. Plug USB charging cable into the USB port of the computer
2. Plug the other end of the USB cable into the headset.
Red light on: Charging
Red light off: Finish charging
3. It will take about 2.5 hours to complete the charging.
2. Pairing the Headset with Bluetooth Devices
1) How to enter Pairing Mode
Note:
1) The battery is recyclable.
2) Batteries (the battery pack or batteries installed) must not
be exposed to excessive heat, such as in the sunshine or
near to a re.
Getting started
1. Turning the headset on/off
Note:
Pairing mode will last 2 minutes. If no devices can be connected
after 2 minutes, it will return to standby mode automatically.
2) Pairing the Headset with a Bluetooth Mobile Phone
Prior to using the headset for the rst time, you have to pair
it with a Bluetooth-enabled mobile phone. The pairing proce-
dure will vary with different models of mobile phones. Refer
to your mobile phone user’s manual for further information.
The general pairing procedure is as follows:
1) Keep your headset and phone within 1 metre when
pairing.
2) Make the headset enter pairing mode (please refer to
“How to enter pairing mode˝).
3) Activate your cell phone’s Bluetooth function and set your
cell phone to search for Bluetooth devices within range,
and select “i.onik BTH-033” from the list of devices shown.
4) According to the indication, enter password or PIN
number: “0000”.
5) If prompted by your mobile phone to connect, select “Yes”
(this will vary depending on the mobile phone being used).
6) After successful connecting, the blue LED indicator ashes
twice every 4 seconds or ashes 3 times every 4 seconds.
Note:
In order to save power, the headset will turn off automatically
after 5 minutes if no devices are connected.
Functions Operation LED indicator
Turning on Press and hold
MFB button for
3-5 seconds until
blue LED indicator
ashes.
Blue LED indicator
on for one second.
Turning off Press and hold
MFB button for
3 seconds until
red LED indicator
ashes.
Red LED indicator
on for one second.
Functions Operation LED indicator
Entering pairing
mode
Ensure the head-
set is off, and then
press and hold
MFB button for 7-8
seconds until red
and blue LED ash
alternately
Red and blue LED
ash alternately