Need help?Do you have a question about the i-SENS i-SmartCare 10 and is the answer not in the manual?
General| Blood Sample Size | 0.5 μL |
|---|---|
| Measuring Time | 5 seconds |
| Memory | 500 test results |
| Weight | 47 g (with battery) |
| Dimensions | 93.5 x 50.0 x 15.5 mm |
| Measuring Range | 20 to 600 mg/dL |
| Operating Conditions | 10°C to 40°C, 10% to 90% relative humidity |
| Storage Conditions | 10% to 90% relative humidity |
| Type | Blood Glucose Monitoring System |
Guidelines for safe operation and handling of the i-SmartCare 10 analyzer.
Explanation of symbols and technical terms used in the operator's manual.
Overview of the i-SmartCare 10 Blood Gas Analyzer and its components.
Details on unpacking, environment, and electric power requirements for setup.
Step-by-step guide for connecting the power cord and adapter.
Instructions for turning on the analyzer and initial boot-up process.
Procedure for installing the printer paper roll into the analyzer.
Detailed steps for inserting and installing a new cartridge.
Overview of the analyzer's screen menu structure and navigation.
Configuration settings for date, time, name, sample type, and other parameters.
Selection and configuration of measured and calculated test parameters.
Creating and managing groups of parameters for specific workflows.
Setting the measurement units for various parameters displayed on the analyzer.
Configuration of reference ranges and critical limits for sample analysis.
Procedure for setting up Quality Control (QC) lots and parameters.
Configuration for Levey-Jennings (L-J) charts for QC data analysis.
Configuration of serial and TCP/IP interfaces for data transmission.
Selection of the operating language for the analyzer interface.
Steps to start a new sample analysis on the analyzer.
Procedure for introducing blood samples (syringe or capillary) for analysis.
Procedure for performing Quality Control (QC) sample analysis.
Viewing and managing previously analyzed sample results and lists.
Accessing and managing Quality Control (QC) results and statistics.
Viewing historical calibration data and results.
Viewing and copying cartridge usage and data information.
Step-by-step guide for safely shutting down the analyzer.
Procedures for analyzer restart and cartridge recovery after power interruption.
Instructions for performing 1-Point, 2-Point, and O2 calibrations.
Procedures for removing expired or used cartridges from the analyzer.
Viewing details about the currently installed cartridge and its status.
Information about the analyzer's software, firmware, and serial number.
Reviewing recorded events and errors for troubleshooting.
Monitoring the analyzer's current status, including sensor and instrument status.
Guidelines and steps for cleaning the analyzer safely and effectively.
General advice and steps for resolving common analyzer issues.
List and description of error codes encountered during analyzer operation.
Details on measuring parameters, sample types, and environmental requirements.
Technical specifications of the analyzer's hardware, ports, and dimensions.
Specifications for the CarePak cartridge, including uselife and components.
Explanation of the electrochemical principles used for parameter measurement.
Guidelines for collecting and handling blood samples for analysis.
Product numbers and ordering details for various CarePak cartridges.
Information on the warranty period, coverage, and exclusions for the analyzer.
To Next Page
