I.A.C.E.R. S.r.l. 42 MNPG45-00
2. Select EMS programs using TENS/EMS button (the display shows EMS icon);
3. Select PC1 program and confirm it pressing P button;
4. Keep pressed P button for 3 seconds: the timer icon on the lower right side will
start flashing;
5. Adjust therapy time using and buttons and confirm pressing P button;
6. Adjust frequency (flashing icon Hz on the lower left side) using and
buttons and confirm pressing P button;
7. Adjust impulse width (flashing icon μs on the lower left side) using and
buttons and confirm pressing P button;
8. SMART TENS is now ready for the treatment with desired parameters. Press 1
and/or 2 button (the icon of selected channel will start flash) to chose the
channel and increase intensity pressing button;
9. Increase intensity using button till you reach the tollerance limit (confortable
stimulation). If the intensity is too high increase it using button;
10. At the end of the treatment SMART TENS will return to the main menu,
decreasing the intensity to zero.
Stop the program: to stop the treatment press once the ON/OFF button. The timer
resets and the channel output stops.
Treatment programs for muscle strength.
To Next Page
Loading...
