I-Tech T-ONE EVO I - Page 38

IACER SRL MNPG05-07 Ed. 29/03/10 Pag. 36
Preliminary instructions.
Before using T-ONE clean the skin of the area to be treated; with the cable disconnected from
T-ONE, connect the electrostimulation cable jacks to the self-adhesive electrodes; position the
self-adhesive electrodes on the skin (see photos of electrode positions); connect the impulse
transmission cables to the relative jacks, then turn T-ONE on.
Warning: make sure that T-ONE is switched off before disconnecting the electrodes at the
end of the treatment.
Operating instructions (N.B. read the whole manual before using the equipment)
1. Turn T-ONE on using the button
2. Select the program group (Sport, Beauty, Tens) using the button
3. Select the program using the buttons
Sport programs display Beauty programs display
4. Select male or female with buttons .
Male selection
Female
selection
5. Select the muscle group with buttons
Arms male
trunk
male
Legs male
Arms female
trunk
female
Legs female
6. press to start program; the display shows connect cables and electrodes and
increase intensity of the used channels; to start intensity press for each used channel; T-
ONE will begin the session.
7. press the button for each use channel to increase current intensity until the personal
tolerance level is reached.